25 Jun 2019

12mm Series 3 Land Rover from Butlers Printed Models

One Series 3 Land Rover. Available in 6mm (1/285), 12mm (1/144), 15mm (1/100), 20mm (1/76) and 28mm (1/56).

The Land Rover series I, II, and III, to distinguish them from later models) are off-road vehicles produced by the British manufacturer Rover Company. The Land Rover was the first mass-produced civilian four-wheel drive car with doors on it. In 1992, Land Rover claimed that 70% of all the vehicles they had built were still in use.

Most series models feature leaf-sprung suspension with selectable two or four-wheel drive (4WD), however series I's produced between 1948 and mid-1951 had constant 4WD via a freewheel mechanism, and the Stage 1 V8 version of the series III featured permanent 4WD. All three models could be started with a front hand crank and had the option of front & rear power take offs for accessories.

The Land Rover is available as either 88" short wheel base (SWB) or 109" long wheel base (LWB), in hard top or cut down open topped.

Four variants of Land Rover are available:

SWB Hard top
SWB open topped
LWB Hard Top
LWB open topped

Series 3 Land Rover

Series 3 Land Rover picture 1

Series 3 Land Rover picture 2

Series 3 Land Rover picture 3

Series 3 Land Rover picture 4

Series 3 Land Rover picture 5

Series 3 Land Rover picture 6

Series 3 Land Rover picture 7

Series 3 Land Rover picture 8

Pictures shown are for 15mm models

All models supplied unpainted, unbased and without crew (figures)

3D printed to order

Butlers Printed Models

No comments:

Post a comment